式胀管机工作范围:200mm --- 3000mm 根据需要可选
立式胀管机主要结构特点:
1.结构形式:本机采用立式布置,手工上、下料,一次装夹中可完成胀管、扩口、翻边工艺过程。
2.二次扩口的长度调整装置由电机减速器、链轮、链条带动丝杠同步旋转,丝杠与编码器相联,并可通过plc的终端机显示长度变化。
3.控制工件二端板距离的下支承可通过电机及蜗轮箱同步升降,液压锁紧。可以选装下丝杆旋转编码器,以实现plc的终端机显示工件长度变化。
4.胀杆快速固定,气缸锁紧。采用胀杆保护装置,在胀管遇到意外情况,造成胀杆弯曲时,保护装置将会自动停止设备下行,避免胀杆的损坏。
5.接收器配有锁紧机构,卸料时不会拔出,而又便于规格变换。还可以选装工件顶出机构(只适合单工位机型),以方便取出工件。
6.1600mm 以下的单工位机型的工件安装平台与门采用铝合金铸件。其它机型的工件安装平台与门采用钢铝复合结构 。
英文简介:1 vertical expander format of structure: the vetical expander adopts
vertical arrangement, load and unload work piece by hydraulic lifting
operation, which can expanding, flaring and refaring in single stroke
2 vertical expander length adjustment of
second expansion is done by motor reducer, sprocket and chain which drive
thread bar to rotate synchronous, thread bar connect with coder and the length
change can be showed on the plc terminal screen.
3 the vertical exander lower supporter
between the two controlling end plates can realize rise and descend synchronous
through the motor and worm gear box, hydraulic lock. you can also choose lower
thread bar rotary coder so as to realize length change can be showed on the
touch screen screen.
4 expanding rod quick fixed, pneumatic lock
and expanding rod protective device are fixed on the machine. the protective
device will stop operating automatically to avoid damaging expanding rod, once
expanding rod run into unexpected case and bend.
5 receiver is provided with locking
structure, which will not be pulled out when unload and it is also convenient
for changing the specification. in order to take out the work piece
conveniently, you can also choose air cylinder to raise the work piece (it`s
only for single working station).
6sve-2000 door use compound structure of
steel and aluminum.
7 the vertical expander provides with two
guide systems, guide column and slide guide rail. the complete machine has good
rigidity.
8 the whole template is processed by
imported machine center with high precision, which can be changed with each
other when the specification is changed.
9.regarding to the model of expander length
more than 1600mm, besides routine manual door for loading and unloading coil,
it also can choose to match to incline 84° for assemble rack. if the coil
length is less than 1200mm, machine also matched with manual work door. (for
manual door, the corresponding holes should be reduced.
宁波赛迪斯机械制造有限公司
15058023312
中国 宁波