33VM52-000-29

Product Details

Product Description

Product Description
Brand:PACIFIC SCIENTIFIC
Type:33VM52-000-29
Origin:the United States
Warranty: 365 days
Colour: new/used
Shipping method: Courier delivery
Products are widely used in metallurgy, petroleum, glass, aluminum manufacturing, petrochemical industry, coal mine, papermaking, printing, textile printing and dyeing, mechanical, electronic manufacturing, automobile manufacturing, plastic machinery, electric power, water conservancy, water treatment/environmental protection, boiler heating, energy, power transmission and distribution and so on.
Spare parts spare parts, the main DCS control system of PLC system and the robot system spare parts,
Brand advantage: Allen Bradley, BentlyNevada, ABB, Emerson Ovation, Honeywell DCS, Rockwell ICS Triplex, FOXBORO, Schneider PLC, GE Fanuc, Motorola, HIMA, TRICONEX, Prosoft etc. Various kinds of imported industrial parts
3. Floor Plan (See Figure 2) a. Identify use and dimensions of all existing and proposed rooms. b. Size and types of windows and doors. c. Location and type of all plumbing fixtures. d. Location and energy output (BTUs) of all heating equipment. e. Location and type of bathroom exhaust fan(s). f. Location and type of smoke and carbon monoxide alarms (see Figure 13). g. Attic access location. 4. Roof Framing Plan (See Figure 3) a. Size, spacing and span between supports for the existing roof framing impacted by the area of alteration. b. Size and spacing of all new rafters and ceiling joists (see Tables 1 and 2). c. Size of headers above wall openings and number of trimmer studs (see Table 4). d. Special framing around roof openings such as skylights and chimneys. e. Size and number of nails for rafter tie connection (see Table 6). f. Wall bracing, shear panels or other means of obtaining required lateral bracing (see Figure 11). 5. Exterior Elevation Views (See Figure 4) a. Each exterior wall shown from the outside of the building and exterior finish of the walls and roof. b. Doors, windows and other openings. c. Pre-existing and finished grade and building height to the most restrictive grade. Note: Roof covering must be minimum Class “A”. Refer to Information Bulletin 123 for requirements concerning renewal of roof covering. 6. Connection Details Sufficient details must be shown to clearly explain the method of construction and means of connection. Details should be referred on framing and foundation plans. a. Refer to Figures 5 through 8 for cross section through addition. b. Refer to Figure 9 for exterior and interior load bearing walls and foundation. c. Refer to Figures 10 and 11 for framing details. d. Refer to Figure 12 for emergency escape windows in bedrooms, and seismic straps for water heaters. 7. Truss Calculations If prefabricated trusses are included as part of the roof framing system, truss calculations stamped by a professional architect or registered civil engineer, licensed in the State of California must be provided. The truss calculations identification number must identify each truss type on the roof framing plan. 8. Site Soils Condition A geotechnical investigation report must be provided for foundations placed on fill material or when placed on expansive soil. Add the following notes on plan when foundations are placed on undisturbed native soil: a.
“The structure(s) will be located entirely on undisturbed native soil." SignatureOwner/Licensed Engineer or Architect. b. "If the Building Inspector suspects fill, expansive soils or any geologic instability based upon observation of the foundation excavation, a soils or geological report, and resubmittal of plans to plan check to verify that report recommendations have been incorporated, may be required." 9. Statement of Special Inspection Specify on plans that special inspection is required when epoxy or expansion anchors are used. When special inspection is required, add the following notes on the statement of special inspection: a. NOTICE TO THE AGENT/ARCHITECT or ENGINEER OF RECORD: By using this permitted