imported raw material PVC fill for cooling tower infill

Product Description

Product Description
Product Detailsimported raw material PVC fill for cooling tower infillCooling tower filling, also named as cooling tower filler, or cooling tower fill media, or cooling tower fill package, is a kind of plastic material panel installed in cooling tower. Its function in cooling tower is to cool down the hot water by increasing the heat dissipation, prolonging cooling waterresisdence time and increasing the heat exchange area. It is made of PVC or PP plain panel in certain mould, with different length, width, thickness and pitch. Different designs of cooling tower fill are suitable for different types of cooling tower.MaterialWidthLengthSheet SpaceCustomized SizePVC/PP (virgin)750mm, 915mm, 1000mm, 1020mm, 1220mm, 1520mm1854mm,2060mm,2450mm,2678mm,2980mm,3090mm19-20mmYesCooling tower fill feature:1. Greater cooling capacity in a given space2. Low-clog designs available3. Available in bottom supported or hanging designs4. FM approval available5. Crossflow and counterflow designs6. Integral louvers and eliminators available in crossflow design.7. High-temperature designs availableigle-piece, full-height counterflow designs available And it has A type and B type which make two loose sheets joint points match very well.Cooling tower fill are hanging on the fiberglass tubes in the cooling tower 2 sides.PVC fill pack for cooling tower is one of the most important components for exchange of gas and water in cooling tower.1.The film fill is probably the most thermally efficient fill worldwide.2.It is well adapted to any induced draft or natural draft cooling tower using normal industrial water quality.3.Sharp horizontal corrugations allow even water redistribution on the sheet and water rotation for good contact with air. The offset flute design allows vertical rotation of air with limited pressure drop.MC75 counter flow cooling tower fill:DF254 counter flow cooling tower fill:Product Processingimported raw material PVC fill for cooling tower infillCooling tower fill is made of PVC or PP plain plate. They are hot pressed in the certain mould, and then be produced according to different design and be used in different cooling towers, especially in the industrial cooling tower.The ML cooling tower fill is one of famous and popular PVC cross flow fills in all brands of the cooling tower fills. It hot sales in the worldwide and have at good lifetime in using.Product packagingimported raw material PVC fill for cooling tower infillCooling tower fill are always packed on pallets with film wrap.Storage Precautions for Cooling Tower Fill:1), Please do not expose the LC PVC fill under the strong sunshine to avoid any deformed. If the outside temperature is higher than 40 degree, the PVC film fill will be deformed within 1-2 hours under the strong sunshine. No matter it is 100% new PVC or recycle PVC, the strong sunshine will deform it very fast. 2),Please do not use the airtight or air impermeability material packing the BL PVC fill, such as the transparent plastic film or bubble plastic film. That will keep the PVC fill in a higher temperature without any cool air come in and may bring some deformed. 3),Please do not use the PVC LC cooling tower fill if the water temperature is more than 60 degree.Packing Method: Carton & Plastic Film, Pallet, Wooden Box or Crate, applicable to the container shipping. Deliver Time: Within 10-15days since receiving the deposit or according to the quantity of your need. Transport Ways: By sea, By air ,By express delivery.For more details, please no hesitant to contact me as following: