Module spare parts 1756-EWEB

Product Details

Product Description

Product Description
Focus on DCS, PLC, robot control system and large servo system.
Main products: various modules / cards, controllers, touch screens, servo drivers.
Advantages: supply of imported original products, professional production parts,
Fast delivery, accurate delivery time,
The main brands include ABB Bailey, Ge / fuanc, Foxboro, Invensys Triconex, Bently, A-B Rockwell, Emerson, ovation, Motorola, xyvom, Honeywell, Rexroth, KUKA, Ni, Deif, Yokogawa, Woodward, Ryan, Schneider, Yaskawa, Moog, prosoft and other brands
1756-EWEB
FiO2 high High Measured FiO2% is higher than the FiO2 high alarm limit. Inspired O2 is greater than the high alarm limit. • Check for additional O2 flow into the patient circuit. • Review the FiO2 high alarm limit in Alarm Setup. • Perform System Check. • Perform airway module calibration. FiO2 low High Measured FiO2% is lower than the FiO2 low alarm limit. Inspired O2 is less than the low alarm limit. • Check the O2 connection. • Check the O2 source. • Review the FiO2 low alarm limit in Alarm Setup. • Perform System Check. • Perform airway module calibration. FiO2 sensor error Medium4 FiO2 cannot be measured due to one of the following issues: • O2 sensor data is invalid • There is a communication error with the O2 sensor The ventilator is not able to measure FiO2. • Perform System Check. Flow control valve error High4 Insufficient inspiratory flow is being measured by the total flow sensor for 65 seconds. The ventilator is not delivering flow. • Prepare to disconnect the patient from the ventilator and manually ventilate. • Check the Air and O2 connections. • Check the air source. • Check the O2 source. • Contact an authorized service representative. FRC error Low An FRC measurement was started for FRC or PEEP INview, but was unable to be completed within the last 5 seconds. The last attempted FRC measurement could not be completed. Ventilation setting changes will stop an FRC measurement. • Install the airway module and allow it to warm up. • Stop active procedures. • Start a new FRC measurement.