100% Solid Rigid Hot Spray Polyurea Coating for Foam Sculpture

Product Description

JHSW8616 100% Solid Rigid Hot Spray Polyurea Coating for Foam Sculpturee is the state of the art 100% solids, ultra-fast cure, flexible, spray-applied, high build, and two components aromatic polyurea elastomer. JHSW8616 has excellent strength, abrasion resistance, substrate adhesion and impact resistance, it has high hardness, so that can be easily polished when spray on the foam sculpture.
Advantages: Fast cure, short down time, no sagging 100% Solids, No VOC's, Odorless, No Toxic Vapors Good resistance to a wide range of chemical attack High impact and Abrasion Resistance Good weather ability High hardness, better protective for foam sculptures. Recommended Uses:
JHSW8616 100% Solid Rigid Hot Spray Polyurea Coating for Foam Sculpture can be widely used for protection of the foam sculptures, it will make the foam sculpture better impact resistance, anti-abrasion, and scratch resistant.
Properties:

Tensile Strength /MPa	≥20	Solids Content/%	100
Elongation/%	≥50	VOC	0
Tear Strength/( N/mm)	≥70	Gel Time/s	11-13
Shore Hardness	≥55D	Tack Free/ s	20~30
Adhesion /(Pull off, concrete,MPa)	≥2.5	Shelf Life	12 months, unopened at 0~40 ºC
Density/( g/cm3)	0.95~1.05	Flash Point/ ºC	>100
Abrasion Resistance /(GB/T 1689-1998, cm3/1.61km, g)	≤0.04	Mix Ratio V/V	1: 1
Impermeability(0.3MPa/30min)	Impervious	Recommended Spreading Thickness/mm	2~3
Chemical Resistance	No corrosion, No Blister, No Spalling	Colors:	Optional